Can / may I bend a thick white router cable?

I have this white router cable. My TV cabinet is about 5 meters to the right of the can. It is difficult to bend the router cable in this direction. I would like to put the router on the TV table so that I can connect my PS4 with the LAN cable.

Can and can you bend / get the cable i-like sharp right?

I haven't really tried it yet because I don't want to destroy it.

So you shouldn't bend it too much, because then the wires of the cable will break.

You can do anything that doesn't destroy it:-)

If you bend it, you will immediately notice how much it can easily withstand. I wouldn't do more.

This is a coaxial cable that you can bend at least it should be able to withstand.

It should not be bent too much. At this point, the impedance changes and the damping increases. It should be a little bow. It doesn't have to be huge, but it doesn't have to bend directly either.

If you bend a coax cable, the capacity changes at the kink… This leads to higher attenuation and thus a weaker signal…

In HF technology, a kink leads to a short circuit in the HF signal…